Vehicle seating, design and manufacture
Over 35 years of engineering excellence
P r o d u c t   I n f o r m a t i o n
M1
M2
M3
Swivl
semi-high back/M1 swivel base
 
This swivel unit interfaces with the Defender III or Nevis to provide full M1 compliancy. The base locks at 90 degree increments to give four seating positions.  When used forward-facing, it is compliant to M1 or M2 and when rear-facing it is complaint to M3 test loads. It may NOT be used side-facing in a moving road vehicle but two further operational positions are provided for use on stationary vehicles. The swivel mechanism is released via an operating lever located on the right hand side of each unit.
More
photos


Product
PDF flyer
 
          
  Compliant to Community Directive 76/115/EEC (as amended)
for category M1, M2 and M3 applications
.
Vehicle category:
Nr of seats:
Maximum weight:
Example:
Compliant:
M1
8 + 1(driver)
-
Private
motor car
YES
M2
More than 8
Not exceeding 5 tons
Minibus
YES
M3
More than 8
Exceeding 5 tons
Coach
YES
     
 
Features
Trim
• Lap/diagonal inertia-reel belt
• Four locking positions - 90° increments 
• Quick-release lever
• Available on 270mm and 320mm 
  standard-rake bases
To match original material in most vehicles.
Vinyls and moquettes also available.
Trim design service
Our Trim Development team can produce unique designs to order. A huge selection of woven cloths, moquettes, vinyls and leathers is available to choose from. Specialist stitching, panel shaping and upholstery effects can be incorporated into your design.
Please contact the office sales team , or speak to your Area Sales
Notes
1 Caution: It is not possible to test every permutation of seat width, accessory combination, leg height, position and type, or seat belt requirement. For this reason, it must be emphasised that compliance cannot be assumed where there is any deviation from the standard supply or assembly method. Additionally, the advantages of this product may be lost if insufficient consideration is given to the method of installation of the seat in the vehicle.
2 FULL compliance to seat belt anchorage regulations can only be achieved through vehicle testing.
3 Product improvement may affect specifications.
  
Rescroft® is a limited company registered in England and Wales. Registered number: 2900615. Registered office: 20 Oxleasow Road, East Moons Moat, REDDITCH, Worcestershire, B98 0RE, UK. VAT No.: GB 641 050582. Tel: +44 (0) 1527 521300 | Fax: +44 (0) 1527 521301. Email: enquiries@rescroft.com
© Copyright 1976 - 2015
Rescroft Ltd. All rights reserved

Web services: Pagelex.co.uk