Vehicle seating, design and manufacture
Over 45 years of engineering excellence
P r o d u c t   I n f o r m a t i o n
folding semi-high back
For vehicle operators, lifting removable, M1 seating into, and out of, vehicles is strenuous and time-consuming. The Plica folding seat is designed to assist in both areas by providing a fold-away facility that eliminates the need to remove the seat at all. Compact and realistically priced, the Plica can be fitted along the full length of the vehicle, simply folding against the side when not in use providing maximum aisle width for wheelchair users. Passengers are seated facing forwards and the seat has been tested and approved to M1 standards.

Available in different heights to suit most vehicles. Please specify vehicle model when ordering. Supplied in single form for both left and right hand applications.


PDF flyer
 Compliant to Reg14 and Reg 80 for category M2/M3 applications.
[Type Approval No. 00870000-80R]  
Vehicle category:
Nr of seats:
Maximum weight:
8 + 1(driver)
motor car
More than 8
Not exceeding 5 tons
More than 8
Exceeding 5 tons
• M1 tested seat belt anchorages
• Forward facing when seated
• Fitted with inertia reel lap and diagonal seat belt
• 200mm deep when folded
• Compliant on Embus floor system
• Aisle-side arm rest
• Headrests (adjustable and removable)

To match original material in most vehicles.
Vinyls and moquettes also available.
Trim design service
Our Trim Development team can produce unique designs to order. A huge selection of woven cloths, moquettes, vinyls and leathers is available to choose from. Specialist stitching, panel shaping and upholstery effects can be incorporated into your design.
Please contact the office sales team , or speak to your Area Sales
Dimensions (for guidance only) 

1 Caution: It is not possible to test every permutation of seat width, accessory combination, leg height, position and type, or seat belt requirement. For this reason, it must be emphasised that compliance cannot be assumed where there is any deviation from the standard supply or assembly method. Additionally, the advantages of this product may be lost if insufficient consideration is given to the method of installation of the seat in the vehicle.
2 FULL compliance to seat belt anchorage regulations can only be achieved through vehicle testing.
3 Product improvement may affect specifications.
4 Leg height restrictions may apply.
M1 double only available using 3 heavy-duty legs.
Rescroft® is a limited company registered in England and Wales. Registered number: 2900615. Registered office: 20 Oxleasow Road, East Moons Moat, REDDITCH, Worcestershire, B98 0RE, UK. VAT No.: GB 641 050582. Tel: +44 (0) 1527 521300 | Fax: +44 (0) 1527 521301. Email:
© Copyright 1976 - 2024
Rescroft Ltd. All rights reserved

Web services: